What To Know
- Clean it with a toothbrush or a small brush to remove any debris.
- The water sensor detects the presence of water in the dishwasher.
- There could be several reasons, including water supply issues, electrical problems, mechanical failures, air in the water line, low water pressure, or a faulty water sensor.
A dishwasher that’s not calling for water can be a frustrating inconvenience. If you’re facing this issue with your Whirlpool dishwasher, don’t worry – you can troubleshoot it using this comprehensive guide. We’ll walk you through the most common causes and provide step-by-step instructions on how to fix them.
Water Supply Issues
1. Check the Water Supply
Ensure that the water supply to your dishwasher is turned on. Check the valve beneath the sink and make sure it’s open.
2. Inspect the Water Inlet Hose
Examine the water inlet hose for any kinks or leaks. Replace it if necessary.
3. Clean the Water Inlet Valve
Mineral buildup can clog the water inlet valve. Remove it and clean it with vinegar or a descaling solution.
Electrical Issues
4. Check the Power Supply
Make sure that your dishwasher is plugged into a working outlet. Reset the circuit breaker or fuse if it has tripped.
5. Inspect the Door Switch
The door switch tells the dishwasher to start filling when the door is closed. Test it with a multimeter to ensure it’s working properly.
6. Check the Control Board
The control board controls the dishwasher’s functions. If it’s faulty, it may not send the signal to call for water. Contact a qualified technician to repair or replace it.
Mechanical Issues
7. Clean the Float Switch
The float switch detects the water level in the dishwasher. Clean it with a toothbrush or a small brush to remove any debris.
8. Inspect the Drain Hose
A clogged drain hose can prevent water from entering the dishwasher. Check for any blockages and clear them.
9. Replace the Water Pump
The water pump circulates water throughout the dishwasher. If it’s not working properly, it may not be able to call for water. Replace it with a new one.
Other Possible Causes
10. Air in the Water Line
Air in the water line can prevent water from flowing into the dishwasher. Turn off the water supply and open the faucet to release any air.
11. Low Water Pressure
Check the water pressure in your home. If it’s too low, the dishwasher may not be able to fill properly.
12. Faulty Water Sensor
The water sensor detects the presence of water in the dishwasher. If it’s faulty, it may not send the signal to call for water. Replace it with a new one.
Final Thoughts
By following these troubleshooting steps, you can diagnose and fix the issue with your Whirlpool dishwasher not calling for water. If you’re unable to resolve the problem yourself, don’t hesitate to contact a qualified appliance repair technician for assistance.
What People Want to Know
1. Why is my Whirlpool dishwasher not filling with water?
There could be several reasons, including water supply issues, electrical problems, mechanical failures, air in the water line, low water pressure, or a faulty water sensor.
2. How do I reset my Whirlpool dishwasher?
Locate the reset button on the dishwasher’s control panel or user manual. Press and hold the button for a few seconds until the dishwasher restarts.
3. How often should I clean my Whirlpool dishwasher?
It’s recommended to clean your Whirlpool dishwasher every 3-6 months to prevent buildup and ensure optimal performance.
